5
Build levels covered by one platform, casting through final assembly
Inspect Systems
Prove your system shipped correctly from a tablet, no fixed camera required.
A defect you didn't cause can still lead to chargebacks weeks later. Scanflow verifies surface condition, part marking, presence, and orientation before dispatch, capturing image-tagged records on a tablet as proof of inspection.
Trusted by Global Enterprises
What Scanflow is
Scanflow is an AI vision platform used by global manufacturers and OEMs to check quality and verify identity at every stage of the build from raw casting to the vehicle that leaves the plant. At the Systems level, that means the point where a completed system is packed and dispatched to the next customer in the chain, and where a mistake becomes very expensive to prove wasn’t yours.
95%+
Detection accuracy, validated the same way at every level
No install
Systems-level capture runs on a tablet no fixed camera, no line downtime to set up
In-line Quality Control
Why catching it here matters
What happens if it’s missed
A system ships, and three weeks later a debit note lands on your desk for a defect that may have happened after it left your dock. Without a record from the moment it shipped, disputing it comes down to your word against theirs.
Where Scanflow checks for it
At the point of dispatch — an operator captures the system on a tablet, Scanflow checks it against spec in seconds, and the result is tagged to that unit’s serial number automatically.
Inspection Capabilities
The four checks that matter at dispatch
Not every capability applies at every level . These are the ones that actually matter for a system about to leave your dock.
Surface Defects
Confirms the tightening witness mark is present and correctly placed not just that a fastener is there.
OCR
Reads the mark and matches it to the build record linked to this exact unit, not a batch.
Presence & Absence
Confirms it's actually present not assumed present because the last unit had it.
Orientation & Alignment
Confirms a connector is fully seated, not clicked partway a common cause of failures found only after dispatch.
Your label data stays under your control
No camera to install, no line to modify the check happens where the system already sits, at dispatch.
Scan the unit
The operator opens the Scanflow app and scans the system's serial number to start the check.
Guided capture
The app guides the operator through the exact angles needed no guesswork about what to photograph.
Checked in seconds
Each capture is checked against spec on the spot a fail is flagged before the unit is packed.
Filed automatically
The result and every image are tagged to that serial number and stored, searchable later.
Why this matters more each year
2×
Growth expected in the digital torque-traceability tools market by 2033
Whole run
Is what a manufacturer often has to recall without traceability not just the affected units
IATF 16949
Requires traceability specifically for safety related components
Same day
Typical time to get a dispatch team checking on a tablet, no install required
Market figures from published industry research (Fortune Business Insights, Grand View Research, 2025–2026 reports on the global precision machining market). India’s precision machining market is specifically noted as a strong growth market, supported by Make in India and PLI investment.
A signature isn’t proof. An image is.
- A checkbox or initial confirms a check happened
- No image of what was actually seen at that moment
- Disputing a debit note means relying on memory, weeks later
- Records live in a filing system, not searchable by part or date
- An image-tagged record of the actual system, captured on a tablet at the moment it shipped
- Serial number linked directly to the images taken for that unit
- Pull the exact record for any unit, any date, in seconds
- No fixed camera or line install works at any dispatch point, day one
Measured, not guessed
95%+
Detection accuracy
100%
Of systems checked & recorded
2x
Faster than manual checks
20–35%
Typical rework reduction
MSA
Validated measurement
